1/9/2024 0 Comments Atf fingerprint cardson Facebook by clicking the “like” button to the right.Īdam Kraut was born and raised in Chester County, PA. Don’t forget to like Firearms Industry Consulting Group and Prince Law Offices, P.C. Once again, we see there is no support for the proposition ATF changed anything. If you are applying to make or transfer an NFA firearm you can roll your own fingerprints, utilize Silencer Shop’s SID kiosk, have your FFL roll your fingerprints or head over to your local law enforcement to have them taken.ĭid you find this blog article helpful? Be sure to share it with your friends by using the buttons below. (b) If the applicant is not a licensed manufacturer, importer, or dealer qualified under this part and is a partnership, company (including a Limited Liability Company (LLC)), association, trust, or corporation, the applicant shall: The fingerprints must be clear for accurate classification and should be taken by someone properly equipped to take them. (iv) Two properly completed FBI Forms FD-258 (Fingerprint Card) for each responsible person. (2) Except as provided in paragraph (c) of this section, attach to the application – (b) If the transferee is not a licensed manufacturer, importer, or dealer qualified under this part and is a partnership, company, association, trust, or corporation, such person shall: (a) If the applicant is an individual, the applicant shall: § 479.63 Identification of Applicant states: In relation to the making of an NFA firearm, 27 C.F.R. (2) Attach to the application two properly completed FBI Forms FD-258 (Fingerprint Card). (a) If the transferee is an individual, such person shall: § 479.85 Identification of Transferee states: In relation to the transfer of an NFA firearm, 27 C.F.R. Therefore, applicants may utilize the service of any business or government agency that is properly equipped to take fingerprints.”Īs if there were any doubt, let us head to the regulations to review them. Fingerprints may be taken by anyone who is properly equipped to take them (see instructions on ATF Form 1, Form 4, Form 5, and Form 5320.23). May a Federal firearms licensee fingerprint a customer? As an FFL dealer, can we fingerprint our customers?Ī. Further if we look at the website the link goes to, we can clearly denote it is in the explosives area by looking at the information found on the left and above the question.ĪTF’s own Q&A relating to ATF 41F states that a licensee may take fingerprints provided they are properly equipped. The fingerprint cards must be completed by your local law enforcement authority.Įmphasis added. These fingerprint cards may be obtained by contacting the Federal Explosives Licensing Center at 87 or the ATF Distribution Center at 70 or 70. The fingerprint cards must contain the following ORI information: WVATF0900 ATF–NATL EXPL LIC, MARTINSBURG WV. This is the same link that SilencerCo had previously used to support its position that Silencer Shop’s Secure Identity Documentation (SID) system would not be acceptable for the purposes of NFA firearms when it had sent an email to a major distributor earlier this year.įingerprints must be submitted on Fingerprint Identification Cards, FD–258 that have been issued by ATF. The problem is that the link goes to the Explosives portion of the website, NOT the firearms part. I’m a bit disappointed in because usually they are an excellent source for correct information. Had the source or looked at where the information came from, they would have clearly been able to see that this is simply not true. To support this position the article links to ATF’s Explosives website.Īs always, the information is provided by an anonymous source. The article claims that ATF now requires law enforcement agencies to take fingerprints rather than anyone qualified to. This morning posted a story which stated that ATF had revised its ruling in relation to fingerprints for NFA firearms.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |